Purchase this Product and Earn 360 Reward Points (R18.00)

Embed Multimould

Earn 360 Reward Points
R360.00

Embed Multimould

 

 

 

Description

This mould size:

Width : 150mm

Length : 150mm

Height: 25 mm. (Adding more or less mix to the mould can make thicker or thinner bath bombs.)

 

Each embed measures 25x25mm, The thickness depends on the amount of mix, plus/minus 10 mm

Makes 25 embeds, embed weight: 7g

 

Makes batch-making fast and efficient and you can quickly use your mix before it dries. You can add the desired amount of your mix to your mould to make a heavier or lighter embed!

This mould consists of 3 pieces – a bottom and a top puck and an outer shell sleeve. They are designed to be used easily by hand without any expensive press required.

Using a plunger mould

Take the outer shell sleeve and place one of the pucks inside the shell sleeve with the flat side down.

Fill the mould lightly (do not pack the mix) to the top of the shell sleeve, or desired weight.

Place the other puck flat side up (facing you) into the shell and press down firmly to pack the mix.

Slide the outer shell sleeve off and lightly tap all round and on the top and bottom to assist in loosening the bomb.

Gently lift the bottom puck off and push the top puck all the way in, exposing the embeds.

Remove and allow to dry.

About our moulds

Our moulds are cast in polyurethane. This makes for easy release and they are hard wearing and not easily susceptible to heat or water damage. There may be some slight discolouration, sanding scratches or defect but this will not affect the performance of the mould or the outcome of the bath bomb! If you find it necessary in time to sand the mould, polyurethane is easily sanded and will not melt.

Polyurethane is easily wiped clean and so minimal cleaning is required and should you need to, it is always advisable to wipe or hand wash the moulds in mild soapy water and not in hot water or a dishwasher and dry them straight away.

We do not cancel orders, accept returns or issue refunds. However, if you receive an item damaged, you should contact us immediately for replacement information.

Colours may vary.

Additional information

Brand

A Good One

Reviews

There are no reviews yet.

Be the first to review “Embed Multimould”